Geological Survey Water-supply Paper, Bände 214-219U.S. Geological Survey, 1907 |
Andere Ausgaben - Alle anzeigen
Häufige Begriffe und Wortgruppen
acre-feet Alaska altitude artesian August Beaver Basin Beaver Valley bench marks bowlders Boyd County Canyon charge County Creek Daily gage height Dakota sandstone deposits depth Discharge in second-feet Discharge measurements district ditch Drainage area drainage basin Dundy County east elevation Escalante Desert feet deep flow Fork formation gallons per minute Geology and water Grand Central River Hydrographer inches intake irrigation July June Lake Bonneville limestone located loess Milford Minersville Miocene Monthly discharge Mountains mouth Nebr Nebraska Niobrara Nome River October open-channel conditions Oreg Pierre shale pipe pumped rainfall Rating table region Republican Republican River River drainage basin Run-off sand and gravel Sec.-ft Sept September Seward Peninsula slopes Soil springs square miles station was established streams surface table is applicable Tertiary thickness Total in acre-feet tributaries Tushar Mountains underground waters upland water resources water supply water-bearing Water-Supply Paper Width Yakima River
Beliebte Passagen
Seite 3 - Second-feet per square mile" is the average number of cubic feet of water flowing per second from each square mile of area drained on the assumption that the runoff is distributed uniformly both as regards time and area. "Runoff, depth in inches...
Seite 7 - ... 0.0737 second-foot per year. 1 foot equals 0.3048 meter. 1 mile equals 1.60935 kilometers. 1 mile equals 5,280 feet. 1 acre equals 0.4047 hectare. 1 acre equals 43,560 square feet. 1 acre equals 209 feet square, nearly. 1 square mile equals 2.59 square kilometers. 1 cubic foot equals 0.0283 cubic meter. 1 cubic foot equals 7.48 gallons.
Seite 3 - Run-off in inches" is the depth to which the drainage area would be covered if all the water flowing from it in a given period were conserved and uniformly distributed on the surface. It is used for comparing run-off with rainfall, which is usually expressed in depth in inches. "Acre-foot...
Seite 5 - Attention is called to the fact that the zero of the gage is placed at an arbitrary datum and has no relation to zero flow or the bottom of the river. In general, the zero is located somewhat below the lowest known flow, so that negative readings shall not occur.
Seite ii - WS 158. Preliminary report on the geology and underground waters of the Roswell artesian area, New Mexico, by CA Fisher. 1906.
Seite 4 - Cubic feet per second per square mile (cfsm) is the average number of cubic feet of water flowing per second from each square mile of area drained, assuming that the runoff is distributed uniformly in time and area. Runoff in inches...
Seite 4 - The standard miner's inch of water shall be equivalent or equal to 1 J cubic feet of water per minute, measured through any aperture or orifice.
Seite v - Fluctuations of the water level in wells, with special reference to Long Island, New York, by AC Veateh.
Seite 4 - March 23, 1901). 1 second-foot equals 38.4 Colorado miner's inches. 1 second-foot equals 40 Arizona miner's inches. 1 second-foot equals 7.48 United States gallons per second; equals 448.8 gallons per minute; equals 646,272 gallons for one day. 1 second-foot equals 6.23 British imperial gallons per second. 1 second-foot for one year covers 1 square mile 1.131 feet or 13.572 inches deep.
Seite 72 - B 199. Geology and water resources of the Snake River Plains of Idaho, by IC Russell.