Was andere dazu sagen - Rezension schreiben
Es wurden keine Rezensionen gefunden.
Andere Ausgaben - Alle anzeigen
altitude amount artesian August basin Beaver beds bench Blue bottom bridge chalk charge clay contain County Creek Dakota deposits depth described discharge Discharge measurements district ditch drainage east eastern extends feet feet deep flow Fork formation Gage height gallons geology given gravel ground inches irrigation July June Lake lands lignite limestone located loess lower March material Mean measurements miles Missouri Mountains mouth Nebraska Niobrara November obtained occur October Oreg Pierre pipe places portion pressure principal rated record region Republican rises River rock sand sands and gravels sandstone sandy Sec.-ft second-feet September shale shown slopes Soil springs square station stream surface Tertiary thickness town underground water United upland upper usually Valley varies Wash water resources water supply western Width
Seite 51 - Second-feet per square mile" is the average number of cubic feet of water flowing per second from each square mile of area drained on the assumption that the runoff is distributed uniformly both as regards time and area. "Runoff, depth in inches...
Seite 5 - ... 0.0737 second-foot per year. 1 foot equals 0.3048 meter. 1 mile equals 1.60935 kilometers. 1 mile equals 5,280 feet. 1 acre equals 0.4047 hectare. 1 acre equals 43,560 square feet. 1 acre equals 209 feet square, nearly. 1 square mile equals 2.59 square kilometers. 1 cubic foot equals 0.0283 cubic meter. 1 cubic foot equals 7.48 gallons.
Seite 51 - Run-off in inches" is the depth to which the drainage area would be covered if all the water flowing from it in a given period were conserved and uniformly distributed on the surface. It is used for comparing run-off with rainfall, which is usually expressed in depth in inches. "Acre-foot...
Seite 3 - Attention is called to the fact that the zero of the gage is placed at an arbitrary datum and has no relation to zero flow or the bottom of the river. In general, the zero is located somewhat below the lowest known flow, so that negative readings shall not occur.
Seite 60 - WS 158. Preliminary report on the geology and underground waters of the Roswell artesian area, New Mexico, by CA Fisher. 1906.
Seite 2 - Cubic feet per second per square mile (cfsm) is the average number of cubic feet of water flowing per second from each square mile of area drained, assuming that the runoff is distributed uniformly in time and area. Runoff in inches...
Seite 52 - The standard miner's inch of water shall be equivalent or equal to 1 J cubic feet of water per minute, measured through any aperture or orifice.
Seite 61 - Fluctuations of the water level in wells, with special reference to Long Island, New York, by AC Veateh.
Seite 52 - March 23, 1901). 1 second-foot equals 38.4 Colorado miner's inches. 1 second-foot equals 40 Arizona miner's inches. 1 second-foot equals 7.48 United States gallons per second; equals 448.8 gallons per minute; equals 646,272 gallons for one day. 1 second-foot equals 6.23 British imperial gallons per second. 1 second-foot for one year covers 1 square mile 1.131 feet or 13.572 inches deep.